Pengaruh Perubahan Sisi Elektrode Sangkar Delta pada Nilai Resistans Satu Batang Pentanah

Harnoko Stephanus

Abstract


Grounding rod is more practical than grounding plate or grounding strip. Grounding resistance value must be set as small as possible. But, it is hard to approach the standard grounding resistance value. There are some methods used to reduce grounding resistance like paralleling ground rod, extending ground rod, or enlarging ground rod diameter. This paper explains the effect of side variation of delta cage electrode (dimension of delta length is 1 meter) on single ground rod resistance value. In this research, ground rod’s length and diameter are 1.5 meter and 10 millimeter, respectively. Ground rod is planted on the ground while the but is on land surface. Grounding resistance value of that single ground rod then is being compared with grounding resistance value of the combination of single ground rod and the delta cage electrode (dimension of delta side are 0.5 meter, 1 meter, and 1.5 meter). This research concludes that: (a) Delta cage electrode (its side are 0.5 meter, 1 meter, and 1.5 meter) with three edge rod length 1.5 meter (diameter 10 millimeter) can minimize grounding resistance value of single ground rod (length 1.5 meter, diameter 10 millimeter) by 29 ohm, 33 ohm, and 40 ohm. (b) Delta cage electrode (its side are 0.5 meter, 1 meter, and 1.5 meter) with six edge rod length 1.5 meter (diameter 10 millimeter) can minimize grounding resistance value of single ground rod (length 1.5 meter, diameter 10 millimeter) by 34 ohm, 37 ohm, and 43 ohm.

Keywords


pentanahan, batang pentanah, elektrode sangkar delta, resistans pentanahan.

Full Text:

PDF

References


Panitia Revisi PUIL, Persyaratan Umum Instalasi Listrik Indonesia 2000, LIPI, Jakarta, 2000.

F. Haryanto Sumbung, “Perlindungan Terhadap Sambaran Petir Peralatan Listrik dan Telekomunikasi dengan Pentanahan yang Disatukan dengan Menggunakan EMTP”, Tesis MSEE, Jurusan Teknik Elektro dan Teknologi Informasi, FT UGM, Yogyakarta, 2008.

Harnoko, 2014, “Pengaruh Elektrode Sangkar Persegi Pada Nilai Resistans Pentanahan 1 Batang Pentanah di Lokasi Sempit”, Laporan Penelitian Hibah JTETI-FT-UGM.

Harnoko Stephanus, “Pengaruh Perubahan Panjang Elektrode Sangkar Delta pada Nilai Resistans Pentanahan 1 Batang Pentanah di Lokasi Sempit”, Laporan Penelitian Hibah DTETI FT UGM, 2015.

T.S. Hutauruk, Pengetanahan Netral Sistem Tenaga dan Pengetanahan Peralatan, edisi ke 2, Penerbit Erlangga, Jakarta, 1991.

A.S. Pabla, Electric Power Distribution, Tata McGraw-Hill Education, New Delhi, 2004.

Harnoko Stephanus, “Pengaruh Bentonit Parit Melingkar Terhadap Nilai Resistans Pentanahan 1 Batang Pentanah di Lokasi Sempit”, Laporan Penelitian Hibah DTETI FT UGM, 2015

Harnoko, 2013, “Pengaruh Elektrode Sangkar Silindris Pada Nilai Resistans Pentanahan 1 Batang Pentanah di Lokasi Sempit”, Laporan Penelitian Hibah JTETI-FT-UGM.

Pijpaert, 1999, Pentanahan Perlengkapan Tenaga Listrik, PLN.




DOI: http://dx.doi.org/10.22146/jnteti.v6i4.359

Refbacks

  • There are currently no refbacks.


Copyright (c) 2017 Jurnal Nasional Teknik Elektro dan Teknologi Informasi (JNTETI)

JNTETI (Jurnal Nasional Teknik Elektro dan Teknologi Informasi)

Departemen Teknik Elektro dan Teknologi Informasi, Fakultas Teknik Universitas Gadjah Mada
Jl. Grafika No 2. Kampus UGM Yogyakarta 55281
+62 274 552305
jnteti@ugm.ac.id